Ericsson RX1290 Guide de l'utilisateur Page 26

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 136
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 25
Installing the Equipment
Page 2-6 Reference Guide: RX1290 H.264 Contribution Receiver
ST.RE.E10228.1
2.3.3 Installing Cables - Safety
Power supply cables should be routed so that they are not likely to be walked on or pinched
by items placed upon or against them. Pay particular attention to cables at plugs, convenience
receptacles, and the point where they exit from the appliance.
Do not run a.c. power cables in the same duct as signal leads. Do not move or install
equipment whilst it is still attached to the mains supply. Ensure safety and ESD precautions
are observed whilst inter-connecting equipment.
2.4 EMC Compliance Statements
1
2.4.1 EN 55022/AS/NZS 3548
This is a Class A product. In a domestic environment this product may cause radio
interference in which case the user may be required to take adequate measures.
2.4.2 FCC
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
commercial environment.
This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the Reference Guide, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own
expense.
2.5 AC Supply Operating Voltage and Fusing – Safety
Information
2.5.1 AC Power Supply
The equipment operates from an wide-ranging mains power supply (100-240 Vac 50/60 Hz
nominal) and is designed for use in ambient air temperature in the range 0°C to +50°C. There
are no links etc. to be altered for operation from different supply voltages. The full Technical
Specification is given in Annex B, Technical Specification.
WARNINGS…
1. THE RX1290 SHOULD ONLY BE OPERATED FROM THE TYPE OF POWER SOURCE
INDICATED ON THE MARKING LABEL. IF YOU ARE NOT SURE OF THE TYPE TO YOUR
BUSINESS, CONSULT YOUR APPLIANCE DEALER OR LOCAL POWER COMPANY. DO NOT
OVERLOAD WALL OUTLETS AND EXTENSION CORDS AS THIS CAN RESULT IN A RISK
OF FIRE OR ELECTRIC SHOCK.
2. THE RX1290 CONTRIBUTION RECEIVERS IS NOT FITTED WITH AN AC POWER ON/OFF
SWITCH. ENSURE THE SUPPLY SOCKET OUTLET IS INSTALLED OR LOCATED NEAR THE
EQUIPMENT SO THAT IT IS ACCESSIBLE.
1
The EMC information was correct at the time of manufacture. The EMC tests were performed with the Technical Earth attached.
Vue de la page 25
1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 135 136

Commentaires sur ces manuels

Pas de commentaire