Ericsson RX8000 Series Guide de l'utilisateur télécharger pdf (Page 16)

RX8200 Advanced Modular Receiver

5 Quick Start Guide - Using the Front Panel Control

5.1 Making Signal Connections to the Unit

!If you have an incoming satellite RF feed, connect this to the rear panel

connector marked RF Input

!If you have an incoming ASI (Fiber) feed, connect this to the connector

marked ASI Input

!Decoded PAL or NTSC video is output on connector CVBS.

! Decoded analogue or digital audio is output on connectors AUDIO OUT 1, 2,

3 or 4. Adaptor cables are used to provide the connector type required for the

installation.

!The incoming feed is routed through the unit and output on connectors

ASI OUT 1, 2 or 3

!For models with option RX83XX/HWO/IP/OUT fitted, the incoming feed is

also routed through the unit and output on connectors IP OUT 1 and

IP OUT 2

!If the unit is to be controlled by Web browser or PC based control system

then the control PC should be connected to connector CONTROL 1 or

CONTROL 2

!If the unit is to be used to decrypt (non-Director) encrypted feeds then a

Conditional Access Module and card should be inserted in the slot labelled

Conditional Access Interface in the front panel

5.2 Configuring the Inputs

5.2.1 ASI Input

To configure the unit for ASI (Fiber) input.

!Select ASI input from a submenu off menu 2

5.2.2 Satellite (DVB-S or DVB-S2) Input

Ensure that the incoming feed is connected to connector 1.

To configure the unit for Satellite input the following User Settings should be

modified. All of these settings may be found in submenus off front panel menu 2.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23 24

Pas de commentaire

Ericsson RX8000 Series Guide de l'utilisateur Page 16