Ericsson TT1222 Guide de l'utilisateur Page 191
- Page / 198
- Table des matières
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
Alarm Categories and Conditions
Table D.11: Output Alarm Categories and Conditions
Alarm
Category
Contents
IP Out alarms:
Alarm Description Remedy Default
Relay
Alarm
The Ethernet link is down.
Note: This is a per port
alarm.
Check Ethernet
cable is plugged
in.
Check far end
equipment (hub
or switch) is
powered.
Check cable is
not faulty e.g.
swap with known
good cable.
Note: The
TT1222 will auto
detect crossover
cabling and
switch TX/RX
lines accordingly.
A
10 Mbps
Link
The link rate is 10 Mbps.
Note: This is a per port
alarm.
This is simply a
warning that the
Ethernet line rate
is 10 Mbps rather
than the more
common
100 Mbps.
A
H/D Not
Supported
The link is half duplex but
the unit cannot support
this link setting.
Note: This is a per port
alarm.
Connect the unit
to a switch or
hub that is full
duplex capable
or configure the
existing
connection to be
full duplex
capable.
A
Bad IP
Unicast host IP address
configuration required.
Note: This is a per port
alarm.
Assign a valid
unicast host IP
address to the
port.
A
Bad Subnet
Subnet mask is invalid for
host IP address.
Note: This is a per port
alarm.
Assign a valid
subnet mask.
A
EN/LZT 790 0002/2 R1A
D-11
- REFERENCE GUIDE 1
- Revision History 5
- Associated Documents 5
- Trademarks 6
- Warnings, Cautions and Notes 6
- EMC Compliance 7
- Contact Information 7
- Preliminary Pages 9
- Preliminary Pages 10
- 1 Introduction 11
- Introduction 12
- Warning! 13
- Caution! 13
- 1.2 Summary of Features 14
- Introduction 15
- 1.2.2 Inputs 16
- 1.2.3 Outputs 16
- 1.3 TT1222 Control Modes 18
- 1.4 Guided Tour 20
- 1.4.3 Rear Panel 22
- 2 Installing the Equipment 23
- Installing the Equipment 24
- 2.1 Read this First! 25
- 2.2 Preliminary Checks 26
- Cautions! 27
- Warnings! 28
- 2.6 Signal Connections 32
- 2.6.2 Input Connectors 33
- 2.6.3 Output Connectors 33
- Installing the Equipment 35
- 2.6.4 RS232 Remote 37
- 2.6.5 Ethernet 38
- 3 Options 39
- Options 40
- 3.1 Available Options 41
- 3.2.1 Limitations 42
- 3.3.2 Dual ASI/SDI Output 45
- (TT1222/HWO/ASI/SDI) 45
- Options 47
- Chapter 4 49
- 4.1 Powering the Equipment 51
- 4.2.3 Editing a Menu Value 52
- 4.5 Service Configuration 53
- 4.6.1 Director 55
- 4.6.3 DVB Common Interface 56
- Chapter 5 57
- 5.1 Remote Control 59
- Step Action Result 62
- 6 Alarms/GPOs 63
- Alarms/GPOs 64
- 6.1 Introduction 65
- 6.2 Status LED 65
- 6.4 Alarm Relay 66
- 6.4.2 Configuring Alarms 67
- Table 6.5 69
- Chapter 7 71
- 7.1 Routine Checks 73
- 7.2 Servicing 73
- 7.2.2 Replacement Parts 74
- 7.3.1 Introduction 74
- 7.3.2 Warranty 74
- 7.3.4 Extended Warranty 75
- 7.5 Fault-finding 76
- A Glossary 77
- Glossary 78
- Glossary 79
- B Technical Specification 97
- B.1 General 99
- B.2 Key Features 99
- B.3 Video Decoder 99
- B.4 Outputs 100
- Parameter Performance 101
- B.4.4 PAN/SCAN 102
- B.4.5 VBI 625 Lines Output 102
- B.4.6 VBI 525 Lines Output 103
- B.4.7 Audio Decoder 103
- B.4.8 Analogue Audio Output 103
- B.4.9 S/PDIF Audio Output 104
- B.5 Data Communication 105
- B.5.3 Ethernet Port 106
- B.7 Options 107
- Parameter Specification 108
- Table B.17: ASI Input 108
- Technical Specification 109
- EN/LZT 790 0002/2 R1A 109
- Technical Specification 110
- EN/LZT 790 0002/2 R1A 110
- B.8 Power Supply 111
- B.9 Physical Details 112
- B.11 Compliance 113
- B.11.3 CE Marking 114
- B.11.4 C-Tick Mark 114
- B.11.5 Packaging Statement 114
- B.11.6 Packaging Markings 114
- B.11.8 Equipment Disposal 116
- B.11.9 Recycling 117
- C Front Panel LCD Menus 119
- Front Panel LCD Menus 120
- Front Panel LCD Menus 121
- C.1 LCD Menus 125
- C.2 Menu Tree 126
- EN/LZT 790 0002/2 127
- Menu Pages - Main Menu 128
- Presets Menu 128
- C.5 Setup Menu 129
- C.5.2 TV Service Menu 130
- Menu title: SET:TV 131
- SERVICE 131
- Description Section 131
- C.5.3 TV Service ID 132
- C.5.4 Audio 2 Service Menu 132
- C.5.5 Audio 2 Service ID 133
- C.5.6 Video Setup 134
- C.5.7 Video 625 Setup Menu 134
- Menu title: SET:VIDEO 135
- C.5.8 Video 525 Setup Menu 137
- C.5.9 Default Output Menu 138
- C.5.10 Audio Setup Menu 138
- C.5.12 Input Menu 141
- C.5.13 Outputs Setup Menu 142
- C.5.14 Alarms Menu 143
- C.5.15 Select Alarms Menu 143
- C.5.16 CVBS Output Menu 144
- C.5.17 GPOs Menu 145
- C.5.18 GPO X Menu 145
- Menu title: SET:REMOTE 147
- C.5.21 LS Data Menu 148
- C.5.22 Data Port Menu 149
- C.5.23 LS Output Menu 150
- C.5.24 ASI Output Menu 150
- C.5.25 ASI/SDI Outputs Menu 151
- C.5.28 IP Output Menu 152
- C.5.31 IP Output Menu 153
- C.5.32 IP Port Setup Menus 154
- C.5.33 IP Config Menu 155
- C.5.35 IP Port Source Menu 156
- C.5.37 IP FEC Menu 158
- C.5.38 CA Menu 159
- C.5.39 BISS Menu 160
- C.5.40 TV / AUD2 BISS Menus 160
- C.5.41 BISS 1 Menu 161
- C.5.42 BISS E Menu 161
- C.5.43 BISS E Key Menu 161
- C.5.44 BISS E User ID Menus 161
- C.5.46 Clear Carriers Menu 162
- C.5.47 System Menu 162
- C.5.48 Control Menu 163
- C.6 Status Menu 164
- C.6.2 Alarm Status Menu 165
- C.6.3 GPO Status Menu 166
- C.6.4 Input Status Menu 166
- C.6.5 Signal Status Menu 167
- C.6.6 TV Service 168
- C.6.7 Video Status Menu 168
- C.6.10 Audio Status Menu 169
- C.6.13 VBI Status Menu 171
- C.6.14 TV Data Status Menu 172
- C.6.15 PID Info Menu 173
- C.6.18 Downld Info Menu 174
- C.6.19 CA Module Menu 175
- C.6.20 CA Info Menu 176
- C.7 Properties Menu 178
- C.7.2 HW Config Menu 179
- C.7.3 Network Menu 179
- C.7.4 IP Address 179
- C.7.5 SubNet Mask 179
- C.7.6 Gateway Address 179
- C.7.7 MAC Address 180
- C.7.8 Customisation Menu 180
- Annex D 181
- Contents 181
- D.1 Alarm Conditions 183
- D.2 Input Stage Alarms 183
- D.3 Output Stage Alarms 184
- D.3.2 Audio Output Alarms 185
- D.3.3 VBI Output Alarms 186
- D.3.4 Data Output Alarms 187
- D.4.1 CA Related Alarms 188
- D.4.2 PSI/SI Related Alarms 188
- D.5 Config Alarms 189
- D.6 OAC Alarms 190
- D.7 IP Out Alarms 190
- Category 191
- Annex E 193
- E.1.1 Getting Started 195
- E.2.1 Scope of This Section 196
- E.2.3 Store Carrier Data 196
- E.2.4 Set Power up Carrier 196
- E.2.5 Force Carrier Retune 196
- E.2.8 Set Relays 197
- E.2.9 Local Lockout 197
- E.2.10 Abort NCP Command 197
Produits connexes et manuels pour Récepteur Ericsson TT1222
(8 pages)
(197 pages)© 2020, manymanuals.fr. Tous droits réservés | 0.104 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels