Ericsson RX8000 Series Spécifications télécharger pdf (Page 6)

Receiver Installation and Cable Connections

RX8200 Configuration Guide

2 RECEIVER INSTALLATION AND CABLE CONNECTIONS

Mount the RX8200 on a 19-inch standard rack in an MCR or CER that has an RF satellite feed to Reuters

RLS/WNE.

Figure 3 Rear Connections On RX8200

2.1 REPLACING AN EXISTING EMR SATELLITE RECEIVER

There will be many instances where the RX8200 unit is being installed on a client site to replace an existing EMR

satellite receiver. In such cases, it is very important to note the following:

 There will be a change between MAC addresses on each receiver model which will interrupt the decryption

of video across WNE.

 This process should be managed in conjunction with the ICA Team in London. See Appendix 1 at the end

of this guide for help.

 There is a separate management interface required for the RX8200 receiver. (On the EMR receiver, both

WNE data and receiver management are controlled over one ethernet connection).

 There may be more than 1 WNE PC/Server connected to an existing EMR receiver.

2.2 RF CONNECTION

Connect an RF coaxial cable that is carrying the Reuters RLS/WNE satellite signal to RF In 1 on the rear of the

RX8200. This may be the existing RF cable that is connected on the rear of an existing EMR receiver. See Figure

3 of an EMR.

Figure 4. RF Connection on RX8200.

1 2 3 4 5 6 7 8 9 10 11 ... 36 37

Pas de commentaire

Ericsson RX8000 Series Spécifications Page 6