Table of Contents
RX8200 Configuration Guide 3
TABLE OF CONTENTS
1 Introduction 5
1.1 Front Panel Controls 5
1.2 Front Panel LEDs 5
2 Receiver Installation and Cable Connections 6
2.1 Replacing An Existing EMR Satellite Receiver 6
2.2 RF Connection 6
2.3 IP Data And Management Connection 7
2.4 Management Address Configuration 7
3 Receiver Configuration 8
3.1 Satellite Parameters 8
3.2 Using the Receiver Front Panel Menu System 9
3.3 Default IP Address – Front Panel Control 9
3.4 Configuration Of RX8200 on RLS – Front Panel Control 9
3.5 Configuration Of Network Access 10
3.6 Configuration Of RX8200 on RLS – Browser Interface 10
3.7 Automated Configuration Script 12
3.8 Default Service Preset 14
3.9 Recording The MAC Address 15
3.10 Recording the Unique Hardware ID 16
3.11 Saving a Configuration File 17
3.12 Restoring A Configuration File 18
3.13 Reset to Factory Defaults 19
4 Troubleshooting 20
4.1 Unable to lock to the WNE signal 20
4.2 Not getting IP Data from WNE 20
5 FAQs 21
5.1 Does the RX8200 receiver work with the older WNE PCs? 21
5.2 How Do I Set Aspect Ratio 16:9 & 4:3 21
5.3 Can the RX8200 be configured to Take an ASI Input Instead of RF? 21
5.4 Can I connect To The Additional Management Control Port? 22
5.5 What type of LNB should be used on a satellite dish for receiving WNE? 22
Appendix 1 i
1.1 MAC Address Change – Replacing an EMR receiver with an RX8200. i
1.2 ICA Contacts ii
Commentaires sur ces manuels