Ericsson EDACS MDX Manuel de l'opérateur télécharger pdf (Page 22)

SQUELCH

The Squelch Window, shown in Figure 7, is accessed by selecting F1

Calib from the Maintenance Screen and then F1 Next or F2 Prev until

the window appears. This window allows the user to align the squelch

setting. Upon pressing F4 Rx On, the programmer will put the radio into

receive mode. The screen will display a blinking field, "RECEIVER ON",

to indicate that the radio is receiving. The radio will remain in receive

mode until F4 Rx Off is pressed.

In addition to entering a value from the keyboard, there are key

actions available as described below:

<+> Increments the field by 1 and writes the new value to

the radio if the receiver is on.

<-> Same as <+> only it decrements.

↑↓→← Arrow keys move the cursor between fields on the

screen.

NOTE

While adjusting the radio, DO NOT disconnect the radio from

the PC interface at any time.

Figure 7 - Squelch Window

LBI-38898

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 28

Pas de commentaire

Ericsson EDACS MDX Manuel de l'opérateur Page 22