Ericsson LBI-38823D Manuel d'utilisateur Page 1

Operator’s ManualDual Format PCSPortable RadioLBI-38823D

SThe Select buttons are two momentary (auto ramp-ing) switches used to increment or decrement thecurrent Group/Channel selection. Pressing theshift b

LOCKThe LOCK key in combination with the SHIFT/CLRkey is used to lock the key pad. All buttons and keyswill be locked except the VOLUME, PTT, HOME/E,

System And Group/Channel IndicatorsThe SYStem display indicates the number of thecurrent EDACS, GE-MARC or Conventional sys-tem selected.The GRP (Grou

SVEDACS - The Service flag is normally on to indicateservice. If a no service condition occurs the SV flagand the No Service flag will be illuminated

ALERT TONESThe Dual Format PCS radio generates a number of alert tones toindicate various events. The following section describes the alert tones fo

Call ReceivedIf programmed, a single alert tone sounds when a group call is receivedand a two tone alert (one high followed by one low tone) is sounde

Out Of Range/System InoperativeEDACS - A single low pitched tone will sound immediately after thePTT switch is keyed indicating the radio is out of ra

OPTIONS AND ACCESSORIESOPTION # DESCRIPTIONPCAC1C Earphone UDC Connector Only (FM APPROVED)PCAC1J Earphone Without UDC Connector (FM APPROVED)PCAE1X S

Figure 6 - Options And Accessories18

BATTERY PACKSThe following battery pack are available for use with the Dual FormatPCS radio:PCPA1J(19A705293P1)Rechargeable Battery Pack, High Capaci

Copyright © September 1992, Ericsson GE Mobile Communications Inc.This manual is published by Ericsson Inc., without any warranty.Improvements and cha

REMOVING THE BATTERY PACK1.Ensure the ON/OFF switch on the battery pack is in the off position.2.Press down on the battery release latch and slide the

Figure 8 - Removing the Battery PackFigure 7 - Installing the Battery Pack21

RECHARGEABLE BATTERY PACK DISPOSALThe product that you have purchased contains a re-chargeable battery. The battery is recyclable. At the endof its us

Figure 9 - Swivel Mount Removal And Replacement23

OPERATING TIPSThe following conditions tend to reduce the effective range of two-wayradios and should be avoided whenever possible.• Operating the rad

3.It is against the law to send false call letters and false distress oremergency messages.4.The FCC requires that conversations be kept brief and con

NICKEL-CADMIUM BATTERY WARRANTYA. Ericsson Inc. (hereinafter "Seller") warrants to the original pur-chaser for use (hereinafter "Buyer&

EDACS OPERATIONRECEIVING A MESSAGE1.Turn the radio on by sliding the ON/OFF switch on the battery pack, tothe ON position. A yellow area will be visi

5.Using the VOLUME buttons, adjust the volume as necessary.SENDING A MESSAGE1.Turn the radio on and set the desired System and Group as describedunder

1.Press and hold the SHFT/CLR button.2.Use the VOLUME or buttons to adjust the squelch. Pressingthe VOLUME s will open the squelch and pressing

TABLE OF CONTENTSINTRODUCTION . . . . . . . . . . . . . . . . 5DESCRIPTION . . . . . . . . . . . . . . . . . 8CONTR

Interconnect - When the signalling is successfully completed the"BSY" flag turns on and the proper DTMF tones will be sent and heardat the s

characters will be visible at a time with the leading character scrollingoff the display upon each new key entry.3.Press and hold the PTT bar to initi

Sending A Manually Entered Interconnect Call1.Press the SPC key to put the radio into Special Call mode. TheSYStem field will display "SP"

6.When the call is complete, double click the SHIFT/CLR button to exitthe Special Call mode and return to the normal system/group display.Storing Indi

5.Press the STO key (shifted *) to complete the storage procedure.6.Double click the SHIFT/CLR button to exit the Special Call mode andreturn to the n

Interconnect - When the signalling is successfully completed the"BSY" flag turns on and the proper DTMF tones will be sent and heardat the s

SCAN OPERATIONEnable/Disable SCANTo enable Group scanning, press and release the SCAN key. The"SCN" icon will illuminate to indicate scan i

channel is found, the radio will switch to the new system and sound an alerttone. Group selection may change upon switching to the new system.The rad

2.Manually entering the desired numbers from the keypad.In the same manner, stored interconnect numbers (tones) maybe sent by:1.Recalling the desired

1.Press and hold the Emergency key for the programmed duration. Ifprogrammed, an "E" will replace the 10’s digit in the System field anda

TABLE OF CONTENTS (Continued)SCAN OPERATION . . . . . . . . . . . . 36DYNAMIC REGROUPING (Optional) . . . 37DTMF OVERDIAL . . . .

HOME/EMER key will also be inhibited. If the key is programmed forEmergency or Emergency/Home, then the key is not inhibited and anemergency can stil

GE-MARC OPERATIONRECEIVING A MESSAGE1. Turn the radio on by sliding the ON/OFF switch on the battery pack, tothe ON position. A yellow area will be v

5. Using the VOLUME buttons, adjust the volume as necessary.SENDING A MESSAGE1.Turn the radio on and set the desired System and Group as describedunde

SENDING A SPECIAL CALLSCAN Model Radio 1. Press the SPC key to put the radio into Special Call mode and provideaccess to a preprogrammed special call

5.The radio is out of range or the radio is inoperative when the signallingis unsuccessful, the "NO" and "SV" indicators are illum

display "SP" and the GRP (group) field will display the current selectionnumber from the special call list, if no special calls are program

4.Press and release the PTT bar to initiate the call. The radio performsthe necessary signalling required to obtain a working channel. 5.When the sig

"SP" and the GRP (Group) field will display the last accessed callnumber from the preprogrammed Special Call selection or will beblank if n

5.When someone answers, press the PTT bar and speak directly intothe microphone. Release the PTT bar as soon as you stop talking.Messages cannot be r

3.Complete the entry by pressing the # key for individual calls and the *key for telephone interconnect calls. The # key indicates the digitsentered

INTRODUCTIONThe Dual Format PCS Portable Radio provides reliabletrunked communication in the 800 MHz band. Advanced DualFormat technology allows th

1.Press the SPC key to put the radio into Special Call mode to send thestored call using the programmed special call tone set, otherwise thecall will

All channels are busy when the signalling is unsuccessful and a onesecond low frequency tone is heard at the speaker. The call will notbe retried aut

WIDE AREA SYSTEM SCANThe Dual Format PCS radio operating within a GE-MARCsystem may be programmed to scan up to 20 channels fromother GE-MARC system

2.Use the SELect buttons or to select the desired Channel. TheGRP icon will be surpressed, but the field will still display the currentChannel sel

SENDING A MANUALLY ENTERED INTERCONNECT CALL1.Select a channel in your radio system that has telephone interconnectcapability. The radio should be pro

1.Select the desired channel to be added. If the current channel is alreadyincluded in the scan list, the "S" icon will be illuminated.2.To

This page intentionally left blank56

CONVENTIONAL MODE OPERATIONThe procedures in the following section describes Conven-tional Mode operation. Each conventional channel may beprogrammed

SENDING A MESSAGE1.Turn the radio on and set the desired System and Channel as describedin the previous section.2.Ensure no one is transmitting on the

2.Press and hold the PTT bar to key the transmitter.3.While holding the PTT bar, press either the * key or the # key asrequired by the radio system to

Figure 1 - Dual Format PCS Radio (SCAN Model)6

2.To add the channel to the scan list, press the SHIFT/CLR key and thenpress the SCAN key. The "S" icon will illuminate and the channel wil

OPERATOR’S RADIO SETUPRADIO TYPE: ______________________________FREQUENCY BAND: ______________________________OPERATOR’S NAME:________________________

SYSTEMNUMBERSYSTEMNAMETRK/CNVGRP/CHNNUMBERGRP/CHNNAMEUSE62

WARRANTYA. Ericsson Inc. (hereinafter "Seller") warrants to the original purchaser for use (hereinafter"Buyer") that Equipment man

EMERGENCY NUMBERSPoliceState PoliceFirePoison ControlAmbulanceLife Saving andRescue SquadPrinted in U.S.A.Ericsson Inc.Private Radio SystemsMountain V

Figure 2 - Dual Format PCS Radio (SYSTEM Model)7

DESCRIPTIONCONTROLSON/OFFSWITCHThe ON/OFF Switch is located on the battery pack.Sliding this switch up to the ON position will supplypower to the radi

Figure 3 - SCAN Model KeypadFigure 4 - SYSTEM Model Keypad9