Ericsson EDACS PRISM HP Manuel de l'opérateur télécharger pdf (Page 83)

Receiving A Call

1. Turn on the radio by rotating the POWER ON-

OFF/VOLUME knob clockwise (out of detent). A

short alert signal (if enabled through programming)

indicates the radio is ready to use.

2. Adjust the POWER ON-OFF/VOLUME knob to the

desired volume level.

3. Select the desired conventional system and channel.

The display indicates the current conventional sys-

tem and channel names.

4. The radio is now ready to receive calls.

5. When the radio receives a call (and the correct

encoding is decoded, if programmed and enabled),

it unmutes on the channel and comes on.

Sending A Call

1. Turn on the radio and set the POWER ON-OFF/VOL-

UME knob to the desired volume level. Select the

desired conventional system and channel.

2. Ensure that the channel is not busy by pressing the

CLEAR/MONITOR button to momentarily disable

any channel decoding and unmute the receiver or

observe the display for the absence of . If the

Channel Busy Lockout feature is programmed for the

selected channel, the radio will not transmit when the

channel is busy.

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 103 104

Pas de commentaire

Ericsson EDACS PRISM HP Manuel de l'opérateur Page 83