Ericsson DIALOG 4422 Manuel d'utilisateur télécharger pdf (Page 90)

Accessories

Dialog 4422 IP Office90

Headset Preset

By default the phone is set to Loudspeaker Preset mode, so that

calls are connected to the loudspeaker when you answer or make

calls by pressing a Line key. Also when you dial the number without

lifting the handset, the call is automatically connected to the

loudspeaker.

When you use a headset for your telephone, you can change the

setting to Headset Preset mode to get calls connected to the

headset instead. In Headset Preset mode you can make headset

calls by pressing digits directly (direct dialing). You can also answer

headset calls by pressing a Line key.

Notes:

Independent the type of preset setting, when you lift the

handset the call is always connected to the handset.

Also monitoring works as usual, that is when the

Loudspeaker key is pressed, the call is temporarily

connected to the loudspeaker. Monitoring is only available

for the Dialog 4422 v. 1 phone.

Activation and deactivation of Headset Preset can only be

done when the phone is in idle mode.

To activate Headset Preset:

Press and hold for at least 4 seconds.

A short acknowledgement tone signal is heard.

To cancel Headset Preset:

Â Press and hold for at least 4 seconds.

A short acknowledgement tone signal is heard.

To check the current preset setting:

Ô Line 1 Press.

Either the Loudspeaker or Headset key lamp is turned on,

indicating the current preset setting.

í Press.

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 115 116

Pas de commentaire

Ericsson DIALOG 4422 Manuel d'utilisateur Page 90