Ericsson RX1290 Manuel d'utilisateur Page 63
- Page / 176
- Table des matières
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
Operating the Equipment Locally
3.9 Setting Up the Transport Stream Output (Menu 5)
3.9.1 Set-Up Procedure
Use Table 3.37 to step through the Transport Stream Output set-up procedure using
Menu 5. This allows the Transport Stream for the current Service to be output on the
ASI output connectors.
Table 3.37 Setting Up the Transport Stream Output (TSO)
Step Action Result
1
Go to Menu 5 to enter the
TRANSPORT STREAM OUTPUT
setting.
Press Edit then select one of the
following:
POST INPUT (i.e. as input
Transport Stream);
POST TS DESCRAMBLE (i.e.
post TTV, RAS descrambling);
POST ES DESCRAMBLE (i.e.
post TTV, RAS, Common
Interface, BISS, DIRECTOR
descrambling).
The Transport Stream Output will be formatted
according to the choice made.
2 Press Save to store the choice. The Transport Stream Output (TSO) is now set.
3.9.2 Setting the Output Connector
Use Table 3.38 to step through the Connector configuration procedure using Menu
5.1.
Table 3.38 Setting Up the Output Connector
Step Action Result
1
Go to Menu 5.1 to enter the
Connector configuration.
Edits the Connector output function for BNC
connectors 1, 2 and 3.
2
Press Edit then select one of the
following, for each connector:
DISABLED
ASI
HD SDI
SD SDI
AUTO
The Connectors output will be formatted
according to the choice made.
3 Press Save to store the choice. The Connector output is now set.
EN/LZT 790 0003/2 R1A
3-25
- RX1290 Multi-Format Receive 1
- Contents 3
- Revision History 4
- Associated Documents 4
- Trademarks 4
- Warnings, Cautions and Notes 5
- EMC Compliance 6
- Contact Information 6
- Preliminary Pages 7
- Preliminary Pages 8
- 1 Introduction 9
- Introduction 10
- EN/LZT 790 0003/2 R1A 10
- Warning! 11
- Caution! 11
- 1.2 Summary of Features 13
- 1.2.2 Inputs 15
- 1.2.3 Outputs 15
- 1.3 The Satellite Receiver 16
- 1.3.2 Input Connections 17
- 1.4.2 What the Decoder Does 18
- 1.5 Control Modes 19
- 1.6 Guided Tour 20
- 1.6.4 Rear Panel 21
- 2 Installing the Equipment 23
- Installing the Equipment 24
- 2.1 Read This First! 25
- 2.2 Preliminary Checks 26
- Cautions! 27
- Information 28
- 2.7 Signal Connections 31
- 2.7.2 ASI/HD-SDI/SD-SDI OUT 33
- 2.7.3 CVBS 33
- 2.7.4 Audio Outputs 33
- 2.7.5 SVGA Output (RGB HV) 34
- 2.7.6 Frame Synchronization 35
- 2.7.7 Ethernet 36
- 2.7.8 ASI IN 36
- 2.8 Option Card Connectors 38
- Chapter 3 39
- 3.1 Powering the Equipment 43
- 3.3.1 General 44
- 3.3.2 Navigate Mode 44
- 3.3.3 Edit Mode 45
- 3.4.1 LCD Menu Descriptions 45
- 3.4.3 Entering a Menu Value 46
- 3.5.1 Using Preset Services 47
- TT1290/HWO/DVBS2/IF/CONST) 48
- Step Action Result 50
- 199999 to +199999 pixels) 53
- NTSC framesync offset range 53
- 3.7.5 Setting Video Delay 54
- 3.7.11 Setting Up Teletext 57
- 3.7.12 Setting Up VITC 57
- 3.7.15 Setting Up VPS 58
- 3.7.16 Setting Up WSS 58
- 3.8.1 Introduction 61
- 3.8.4 Director (Menu 4.3) 62
- 3.9.1 Set-Up Procedure 63
- 3.12 Restarting the Unit 66
- Chapter 4 67
- 4.1 Remote Control 69
- 5 Alarms 73
- Alarms 74
- 5.1 Introduction 75
- 5.3 Alarm LED 75
- 6 Options 77
- Options 78
- (RX1290/HWO/DVBS2/IF/CONST) 81
- Options 83
- Chapter 7 87
- 7.1 Introduction 89
- 7.2 Routine Checks 89
- 7.3 Servicing 90
- 7.4.1 Introduction 91
- 7.4.2 Warranty 91
- 7.4.4 Warranty 91
- 7.5 Fault-finding 92
- 7.7 Disposal 94
- A Glossary 95
- Glossary 100
- Glossary 101
- EN/LZT 790 0003/2 R1A 101
- B Technical Specification 115
- Technical Specification 116
- B.1 Output 117
- Table B.3 625 Line 118
- Table B.4 525 Line 118
- B.1.4 Performance Figures 119
- B.1.5 HD SDI 120
- B.2.1 General 121
- B.2.2 MPEG Audio 121
- B.3 Audio Output Format 122
- B.3.3 Audio Routing 123
- B.3.4 Lip Sync 124
- B.4 Input Specifications 125
- Parameter Specification 126
- B.4.2 LNB Power and Control 129
- B.4.4 DVB-ASI Input 130
- B.5 Output Specifications 131
- B.5.1.2 Digital Video 132
- Item Specification 132
- Table B.21 625 Line 132
- Table B.22 525 Line 133
- B.5.2 Audio Outputs 134
- B.5.3 Data Outputs 134
- B.5.5 Alarm Connector 135
- B.6 Environmental 136
- B.7 Compliance 136
- B.8 Safety 136
- B.8.1 EMC 137
- B.8.2 Telecommunications 137
- B.8.3 CE Marking 137
- B.8.4 C-Tick Mark 138
- B.8.5 Packaging Statement 138
- B.8.6 Packaging Markings 138
- Technical Specification 139
- B.8.8 Equipment Disposal 140
- B.8.9 Recycling 140
- C Menus 143
- Menus 144
- C.1 LCD Menus 147
- C.2 Menu Pages - Main Menu 147
- C.3 The Menu Structure 148
- C.5.1 Overview 149
- C.5.2 Input Selection Menu 149
- C.5.3 DVB-S2 Option 150
- RX1290/HWO/DVBS2/IF/CONST) 150
- C.6 Conditional Access Menu 154
- C.7 Service Menu (Menu 3) 155
- C.7.2 Video Menu 156
- Table C.14 Video Menu 157
- C.7.3 Audio 1 Menu 158
- C.7.4 Audio 2 Menu 158
- C.7.5 Audio 3 Menu 159
- C.7.6 Audio 4 Menu 159
- C.7.7 Async Data Menu 160
- C.7.8 Ethernet Data Menus 160
- C.7.9 VBI Menu 161
- C.7.10 PCR PID Menu 161
- C.7.11 Network ID Menu 161
- C.9 Alarms Menu (Menu 6) 162
- C.10 System Menu (Menu 7) 165
- Table C.38 CR Details Menu 166
- C.10.3 System Restart Menu 167
- D Language Abbreviations 169
- Language Abbreviations 170
- D.2 Non-ISO Languages 171
- E Factory Defaults 173
- Menu Description Default 174
Produits connexes et manuels pour Matériel d'enregistrement Ericsson RX1290
(300 pages)© 2020, manymanuals.fr. Tous droits réservés | 0.377 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels