Ericsson RX8000 Series Guide de l'utilisateur Page 181
- Page / 236
- Table des matières
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
Chapter 7
Warning!
Before replacing the rear panel fuse, disconnect the unit from the supply. Failure to
do this may expose hazardous voltages. Unplug the unit from the local supply
socket.
1. Ensure that power is turned off and the power cable is disconnected from the
AC power inlet.
2. Ease out the fuse carrier by placing a small, flat-bladed screwdriver in the notch
at the top of the carrier.
Caution...
When replacing the power input fuse, always ensure that a fuse of the correct type
and rating is fitted. Failure to do so may result in inadequate protection.
3. Replace the fuse in the carrier.
4. Insert the fuse carrier back in the AC power inlet.
Fuse Carrier
To access the fuse, ease out
the notch with a small flat-
blade screwdriver.
AC Power Inlet
Figure 7.1 Fuse Carrier
If the replacement fuse also blows, do not continue. Disconnect the equipment and
contact Ericsson Customer Services (see Preliminary Pages) for advice.
7.4.5 Power Supply Problems
Warning!
Do not attempt to service the Power Supply Unit as opening or removing covers
may expose dangerous voltages or other hazards. Refer all servicing to service
personnel who have been authorized by Ericsson.
Use the following techniques to fault-find according to the observed symptom(s)
when a power supply failure is suspected.
EN/LZT 790 0005 R1A
7-7
- RX8000 Series Receivers 1
- Introduction 4
- Revision History 4
- Associated Documents 4
- Trademarks 4
- Macrovision 5
- Warnings, Cautions and Notes 5
- EMC Compliance 6
- Contact Information 6
- Preliminary Pages 7
- Preliminary Pages 8
- 1 Introduction 9
- Chapter 1 10
- EN/LZT 790 0005 R1A 10
- 1.1 Introduction 11
- Chapter 1 13
- 1.2 Summary of Features 18
- 1.3 The Satellite Receiver 25
- 1.4.2 What the Decoder Does 27
- 1.5 Construction 28
- 1.6 Front Panel 28
- Item Color Description 29
- 1.7 Rear Panels 30
- Table 1.13 Rear Panels 31
- Item Type Description 31
- 2 Installing the Equipment 33
- Chapter 2 34
- 2.1 Read This First! 35
- 2.2 Preliminary Checks 36
- Information 38
- Warnings! 39
- 2.7 Signal Connections 41
- 2.7.6 CVBS Connector 44
- 2.7.9 ASI IN Connector 46
- 2.7.11 DATA OUT Connector 47
- 2.7.12 ALARM Connector 47
- Item Specification 48
- 3 Front Panel Control 49
- 3.1 Introduction 51
- 3.2 Powering the Equipment 51
- 3.3.1 USB Connector 53
- 3.3.2 Status LED 53
- 3.3.3 LCD 53
- 3.4 Example Configuration 55
- 3.5 Front Panel Menus 56
- 2 64
- INPUT 64
- 2.1 64
- 2.2.4.5 80
- 2.2.4.6 80
- 2.2.4.7 81
- I/P PORT 81
- 2.2.5 81
- 2.2.5.1 81
- STREAM 1 83
- 2.2.6.3 83
- STREAM 1 83
- 2.2.6.4 83
- 2.2 87
- 2.3 87
- INPUT 88
- 2.1 88
- 3.2.3 97
- VIDEO 97
- 3.2.4 97
- AUDIO 99
- 3.4 99
- CH1+2 99
- 3.4.1 99
- Chapter 3 100
- Chapter 3 101
- EN/LZT 790 0005 R1A 101
- 4.2.8 103
- DIR 103
- 4.2.9 103
- 5.1.2 105
- OUTPUT 105
- 5.2 105
- 4 Remote Control 109
- Remote Control 110
- 4.1 Introduction 111
- 4.2 RS232/485 RCP 111
- 4.3 Director 112
- 4.4 Web Browser 113
- 4.5 SNMP 114
- 4.5.2 Downloading the MIB 115
- 5 Web Browser Control 117
- Chapter 5 118
- 5.1 Introduction 119
- Item Description 121
- 5.2 Web Pages 122
- 5.2.2 Device Info 123
- Chapter 5 125
- 5.2.3 Alarms 127
- 5.2.4 Customization 128
- 5.2.5 CA 130
- 5.2.10 Service Plus 141
- 5.2.11 Decode 142
- 5.2.12 Output 151
- 5.2.13 Download 153
- 5.2.14 SNMP 154
- 5.2.15 Presets 155
- 5.2.16 Save/Load 156
- 5.2.17 Help 158
- 6 Options 159
- Chapter 6 160
- Chapter 6 161
- Option Number Description 162
- Cautions! 163
- (RX8200/HWO/RS232) 165
- Chapter 7 175
- Contents 175
- 7.1 Introduction 177
- 7.2 Preventive Maintenance 177
- 7.3.1 Introduction 178
- 7.3.2 Warranty 178
- 7.4 Fault-finding 179
- Caution 180
- Warning! 181
- 7.5 Disposal 183
- 7.5.2 Equipment 184
- A Glossary 185
- Annex A 186
- Annex A 187
- B Technical Specification 205
- Annex B 206
- B.1 Output 207
- VITS17 +/- 100mV 208
- NTC-7 comp +/- 100mV 209
- ± 10 mV ± 10 mV 209
- B.1.5 HD SDI Digital Video 211
- B.2.1 General 211
- B.3 Audio Output Format 212
- Parameter Specification 213
- B.3.3 Audio Routing 214
- B.3.4 Lip Sync 214
- B.4 Input Specifications 215
- Rs = Symbol-rate (Msymbol/s) 217
- Channel bandwidth 6 MHz 219
- B.4.3 DVB-ASI Input 220
- B.4.5 Frame Sync Connector 220
- B.5 Output Specifications 221
- B.5.4 DVB-ASI Output 222
- B.5.5 1000BaseT IP Output 222
- B.6 Environmental 223
- B.8 Cable Types 224
- B.9 Compliance 225
- B.9.2 EMC 226
- B.9.3 Telecommunications 226
- B.9.4 CE Marking 226
- B.9.5 C-Tick Mark 227
- B.9.6 Packaging Statement 227
- B.9.7 Packaging Markings 227
- B.9.9 Equipment Disposal 229
- B.9.10 Recycling 229
- C Language Abbreviations 231
- Annex C 232
- C.1 ISO Languages 233
- C.2 Non-ISO Languages 234
- Annex C 235
Produits connexes et manuels pour Récepteur Ericsson RX8000 Series
Récepteur Ericsson LBI-38505A Spécifications
(12 pages)
(12 pages)
Récepteur Ericsson RX1290 Guide de l'utilisateur
(136 pages)
(136 pages)
Récepteur Ericsson RX8330 Spécifications
(39 pages)
(39 pages)
Récepteur Ericsson TT1222 Guide de l'utilisateur
(198 pages)
(198 pages)
(197 pages)© 2020, manymanuals.fr. Tous droits réservés | 2.097 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels